LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Gears & Shafts System (Service Information - Manual Transmission - 02Q, 02QA)) >> 35 Gears, Shafts >> Output Shaft >> Output Shaft, Disassembling And Assembling >> Output Shaft, 5TH, 6TH And Reverse Gears, Disassembling And Assembling >> Dimensions Of Synchronizer Rings A And B

Dimensions Of Synchronizer Rings A And B

WARNING: This page is about a different variant/trim than selected.
-A- = brass synchronizer ring - -
Gap dimension -a- Installation Dimension Wear limit
5th and 6th gear 1.0 to 1.7 mm 0.5 mm
-B- = steel synchronizer ring - -
Gap dimension -a- Installation Dimension Wear limit
5th and 6th gear 1.2 to 2.1 mm 0.8 mm

-- Press synchronizer ring onto taper of the gear wheel and measure gap dimension -a- using a feeler gauge.

scientia non olet · About LEMON Manuals