Removing 3RD And 4TH Gear Synchro-Hub/Locking Collar
WARNING: This page is about a different variant/trim than selected.
-- Remove the locking ring beforehand.
A - Puller, for example, Puller - Kukko Puller - 60-200mm Width, 250mm Length :Kukko 18/2
B - Puller - Quick Action Separating Tool - 22-115mm, for example :Kukko 17/2
-- Then remove the retaining ring and thrust washers. Refer to -item ) Retaining Ring-, and -item ) Thrust Washer-.
-- Then remove the 1st gear wheel with synchronizer ring.