LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Gears & Shafts System (Service Information - Manual Transmission - 02Q, 02QA)) >> 35 Gears, Shafts >> Output Shaft >> Output Shaft, Disassembling And Assembling >> Output Shaft, 1ST To 4TH Gears, Disassembling And Assembling >> Assembling Gear Locking Collar/Synchro-Hub

Assembling Gear Locking Collar/Synchro-Hub

WARNING: This page is about a different variant/trim than selected.
GWWV35-0981Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The locking collar is pushed over the synchronizer hub.

-- Install the locking pieces and springs offset by 120°. The angled end of the spring must engage into the hollow locking piece.

scientia non olet · About LEMON Manuals