Shim Table
WARNING: This page is about a different variant/trim than selected.
| Thickness (mm) | ||
|---|---|---|
| 1.50 | 1.80 | 2.10 |
| 1.55 | 1.85 | 2.15 |
| 1.60 | 1.90 | 2.20 |
| 1.65 | 1.95 | 2.25 |
| 1.70 | 2.00 | - |
| 1.75 | 2.05 | - |
-- For the correct part numbers.
Tolerance variations make it possible to find the exact shim thickness required.
-- Install the outer race/tapered roller bearing with the selected shim (in the example: 1.65 mm) Support transmission housing directly beneath bearing mount using Slide Hammer - Press Plate :2050 .