Checking Measurement
WARNING: This page is about a different variant/trim than selected.
- The selected adjusting shim is installed.
-- Attach the measuring tools to the clutch housing.
-- Place several washers (total thickness: 8 mm) on the clutch housing at the bolt -arrow- being used to secure the Seal Installer - Stator :VW792 .
-- Set the dial gauge (3 mm range) with 1 mm preload to "0".
-- Loosen securing bolts for clutch housing/transmission housing in diagonal sequence until bolts the clear transmission housing or the output shaft.
- For correctly selected adjustment shim, dial gauge must now display a value of 0.15 mm to 0.25 mm.