Input Shaft, Disassembling

WARNING: This page is about a different variant/trim than selected.

-- Remove the grooved ball bearing locking ring.

Removing The grooved Ball Bearing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Mount the Separating Tool -A- into the groove in the ball bearing for the locking ring.

A - Separating Tool - 22-115mm, for example Puller - Kukko Quick Action Separating Tool - 22-115mm :Kukko 17/2 .

-- The grooved ball bearing and 5th gear wheel can also be removed together. To do this, place the Separating Tool -A- as shown in the following illustration under the 5th gear wheel.