Connecting Rods, Checking Radial Clearance: Procedure
WARNING: This page is about a different variant/trim than selected.
-- Remove the connecting rod bearing cap.
-- Clean the bearing cap and pin.
-- Place the Plastigauge® over the entire width of the bearing journal or into the bearing shells.
-- Position the connecting rod bearing cap and tighten the old bolts -item 1- without turning the crankshaft.
-- Remove the connecting rod bearing cap again.
-- Compare the width of Plastigauge® with calibrated scale.
Radial clearance:
- New: 0.02 to 0.06 mm.
- Wear limit: 0.09 mm.
-- Replace the connecting rod bolts.