Flywheel, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Remove the bolts -B- by hand. Do not use an air-powered or impact wrench.

When removing the bolts, make sure that the bolt head does not come in contact with the flywheel.

Turn the flywheel -A- so that the bolts -B- line up with the center of the holes -arrows-.

-- Place the :3067 into the hole on the cylinder block -B-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen and remove bolts for the flywheel.