Vibration Damper, Installing

WARNING: This page is about a different variant/trim than selected.

-- If necessary, remove the :T10531/4 -B- and the :T10531/3 -A- from the tensioning pin.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Attach the vibration damper in TDC. While doing so, pay attention to the tooth contour of the chain sprocket -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place the :T10531/3 -A- on the tensioning pin. While doing so, the hex fitting points to the vibration damper.

-- Install the :T10531/4 -B-. While doing so, move the vibration damper back and forth slightly to check if the vibration damper is seated correctly in the tooth contour. Tighten the collar nut until the vibration damper can no longer be turned.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place the :T10531/1 as shown on the vibration damper and tighten it hand-tight using the knurled bolts -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the :T10531/4 -A- and loosen the adjusting bolt -B-. Remove the :T10531/2 and remove with :T10531/3 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install a new vibration damper bolt hand-tight with an oiled O-ring -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the knurled bolts -arrows- and remove the :T10531/1 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the vibration damper bolt using the :T10355 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install new bolts -arrows-.

Further assembly is performed in the reverse order of the removal.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.