Sub-Assembly Bracket, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
NOTE:
Replace the O-rings and seals.
-- Coat the new O-rings -4- with coolant. Refer to Parts information for the coolant.
-- Insert the connection -2- into the coolant pump housing -3-.
-- Slide the sub-assembly bracket -1- onto the connection and then install and tighten the bolts. Refer to Figure.
-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING => Filling .
-- Install the oil filter and check the oil level.