Overview - Cylinder Block, Belt Pulley Side

Fig 1: Cylinder Block, Belt Pulley Side Exploded View

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1. Ribbed Belt
   • Check for wear
   • Do not kink
   • Ribbed belt routing. Refer to Installing 
   • Removing and installing. Refer to RIBBED BELT, REMOVING AND INSTALLING .
   • When installing, make sure it is seated correctly on the belt pulleys
2. Ribbed Belt Tensioner
   • To release tension on the ribbed belt, pivot using an open end wrench.
   • Secure using the :T10060A 
   • Removing and installing. Refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING .
3. Bolt
   • 8 Nm +45°
   • Replace after removing
4. Bolt
   • 150 Nm +90°
   • Replace after removing
   • Use the :T10355  to loosen and tighten
5. O-ring
   • Not a replacement part; supplied with the bolt
6. Vibration Damper
   • With ribbed belt pulley
   • Removing and installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
7. Sub-Assembly Bracket
   • Removing and installing. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .
8. Seal
   • Replace after removing
9. Bolt
   • Tightening specification and sequence. Refer to Fig 2.
10. Bolt
    • Tightening specification. Refer to GENERATOR .
11. Generator
    • Overview. Refer to GENERATOR .
12. Alignment Sleeves
    • For the A/C compressor
13. A/C Compressor
    • Do not remove or disconnect refrigerant lines
    • Overview. Refer to A/C COMPRESSOR .
14. Bolt
    • Tightening specification. Refer to A/C COMPRESSOR .

Fig 2: Sub-Assembly Bracket Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Mount the sub-assembly bracket and then install the bolt -4- by hand.

-- Tighten the bolts in the sequence -1 to 5- in three stages as follows: