Overview - Balance Shaft
WARNING: This page is about a different variant/trim than selected.
- Bolt
- 4 Nm + 45° additional turn
- Replace after removing
- Balance Shaft
- Must be replaced after removing
- Exhaust side
- Lubricate the bearing with engine oil
- Replacing. Refer to BALANCE SHAFT, REMOVING AND INSTALLING, EXHAUST SIDE .
- Needle Bearing Rim
- Replace each time the balance shaft is removed
- No replacement part; part of the balance shaft delivery package
- Balance Shaft Pipe
- Installation position. Refer to 9
- Cylinder Block
- Intake Side Balance Shaft Seal
- Replacing. Refer to BALANCE SHAFT SEALING RING, REPLACING, INTAKE SIDE .
- Balance Shaft
- Must be replaced after removing
- Intake side
- Lubricate the bearing with engine oil
- Replacing. Refer to BALANCE SHAFT, REMOVING AND INSTALLING, INTAKE SIDE .
- Needle Bearing Rim
- No replacement part; part of the balance shaft delivery package
- Bolt
- Replace after removing
- 4 Nm + 45° additional turn
- The openings -arrow- must face the chain side.