Balance Shaft, Removing And Installing, Intake Side: Installing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Lubricate the balance shaft mountings -arrows- with engine oil.

-- Install the intake side balance shaft and tighten the bolt -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Replace the O-ring -1- and coat with engine oil.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Coat the mounting pin with engine oil and insert it. The alignment pin -arrow- for the mounting pin must engage in the cylinder block hole.

-- Mark the tooth flank on the intermediate sprocket -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the intermediate sprocket; the marking on the balance shaft must be between the markings on the tooth flanks.

-- Tighten the bolt -1- for the intermediate sprocket: tightening sequence. Refer to the illustration below.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Check the markings on the intermediate sprocket/balance shaft -arrow-.

Further assembly is performed in the reverse order of the removal. Note the following:

-- Install the balance shaft drive chain. Refer to BALANCE SHAFT DRIVE CHAIN, REMOVING AND INSTALLING .

-- Install the camshaft timing chain. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .

-- Install the lower timing chain cover. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .

-- Install the upper timing chain cover. Refer to UPPER TIMING CHAIN COVER, REMOVING AND INSTALLING .

-- Replace the intake side balance shaft seal. Refer to BALANCE SHAFT SEALING RING, REPLACING, INTAKE SIDE .

-- Install the toothed belt on the coolant pump. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .