Balance Shaft, Removing And Installing, Exhaust Side: Installing

WARNING: This page is about a different variant/trim than selected.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Check the installed position for the balance shaft pipe. The openings -arrow- must face the chain side.

-- Lubricate the balance shaft mountings -arrows- with engine oil.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the exhaust side balance shaft.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Before tightening the bolt -1- make sure the balance shaft lies level on the crankcase.

NOTE:

If the balance shaft is not level, then the pipe for the balance shaft must be installed again.

Further assembly is performed in the reverse order of the removal. Note the following:

-- Install the balance shaft drive chain. Refer to BALANCE SHAFT DRIVE CHAIN, REMOVING AND INSTALLING .

-- Install the camshaft timing chain. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .

-- Install the lower timing chain cover. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .

-- Install the upper timing chain cover. Refer to UPPER TIMING CHAIN COVER, REMOVING AND INSTALLING .