Balance Shaft Sealing Ring, Replacing, Intake Side: Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the coolant pump toothed belt. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .

-- Remove the bolt -2-.

-- Remove the drive wheel -1- for the coolant pump toothed belt.

-- Firmly press a screwdriver -1- on the seal surface -2- in direction of -arrow B-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pry out the seal in direction of -arrow A-.

-- Clean the contact and sealing surface.

-- Coat the sealing surface of the balance shaft -2- with transmission oil.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the shaft seal -1- onto the balance shaft.

"Luftseite" or ("Outside") -arrow- must be readable from the outside.

NOTE:

The bolt for the drive wheel -2- has left-hand thread.

-- Mount the :T10353/1 on the shaft seal -1- and then press it all the way into the cylinder block with the bolt -2-. While doing so, do not to tilt the shaft seal.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the toothed belt on the coolant pump. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING => Filling .