LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Lubrication System (Service Information - 1.8L & 2.0L TFSI - CPLA, CPPA, CPKA, CPRA)) >> 17 Lubrication >> Oil Pan/Oil Pump >> Oil Pan Upper Section, Removing And Installing >> Removing

Oil Pan Upper Section, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the oil pan lower section. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .

-- Remove the transmission side sealing flange. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .

-- Remove the oil pump. Refer to OIL PUMP, REMOVING AND INSTALLING .

-- Disconnect the connector -1-.

GWWA17-10826Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
NOTE:

Ignore -2-.

-- Remove the bolts -arrows-.

GWWN17-10200Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -1 through 14- and the upper section of the oil pan.

Fig 1: Oil Pan Upper Section - Tightening Sequence
GWWA17-10823Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Note: Loosening and tightening sequence is the same.

-- First pry the oil pan upper section out on the transmission side. When prying out, be careful not to bend the timing chain cover.