Valve Guides, Checking

WARNING: This page is about a different variant/trim than selected.

Special Tools And Workshop Equipment Required

Dial Gauge Holder :VW387
Dial Gauge - 0-10mm :VAS6079

Test Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert the valve into guide. The valve stem end must be flush with the guide. Due to differences in valve stem diameter, only use intake valves in intake valve guides, and exhaust valves in exhaust valve guides.

-- Determine the tilting clearance.

Wear limit: 0.5 mm.

-- If the wear limit is exceeded, measure using new valves.

-- Replace the cylinder head if the wear limit is still exceeded.

NOTE:

The valve guides cannot be replaced.