Tightening Specifications

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Cylinder Head

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Replace the bolts that were tightened with an additional turn.

-- Tighten the bolts in steps in the sequence -1 to 10- :

Step	Component	Tightening Specification/Additional Turn
1	Bolts -1 through 10-	40 Nm
2	Bolts -1 through 10-	90° additional turn
3	Bolts -1 through 10-	90° additional turn
4	Bolts -1 through 10-	90° additional turn