Tightening Specifications
WARNING: This page is about a different variant/trim than selected.
- Bolts -1 to 4- : M6 X 52
- Bolts -5 to 15- : M6 X 65
- Replace the bolts that were tightened with an additional turn.
NOTE:
There are different bolt lengths.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Component | Tightening Specification/Additional Turn |
|---|---|---|
| 1 | Bolts -1 to 15- | 10 Nm |
| 2 | Bolts -1 to 15- | 180° additional turn |