Electric Drive Motor -V141-, SEPARATING FROM ENGINE: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Used Oil Collection and Extraction Unit:SMN372500
- Engine Bung Set:VAS6122
- Shop Crane - Drip Tray:VAS6208
- Scissor Lift Table:VAS6131B
- Hose Clip Pliers:VAS6362
- Engine Support:T10497
- Hose Clamps - Up To 25 mm:3094
- Counter-support, for example Puller - Kukko Counterstay:22/1
- Internal Puller:VAS251605
- Commercially available Step Ladder
- Scissor Lift Table - Adapter Set - Articulated Joint Support:VAS6131/16-3
- Socket - Xzn 8:T40159
- Centering Mandrels:T10515
- Protective Eyewear
- Safety Gloves
NOTE:
Danger of damaging the components.
The center bolt behind the needle bearing has a left-hand thread.
When removing the Electric Drive Motor -V141-, the engine must be secured with the :VAS6131/13-7 on the :VAS6131B .
When loosening the central bolt, counterhold it using the :T10516 and a suitable lever (3/4 inch, square).
Only remove the Electric Drive Motor -V141- from the engine using the :T10515 .