LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Crankshaft & Cylinder Block System (General & Service Information - CNLA, CRJA)) >> 13 Crankshaft, Cylinder Block >> Pistons And Connecting Rod >> Pistons, Removing And Installing >> Installing

Pistons, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

NOTE:

Replace the bolts that were tightened with an additional turn.

-- Coat the contact surfaces on the bearing shells with oil.

-- Install the piston with a commercially available piston ring compressor. Pay attention to the installation position. Refer to Piston Installed Location And Allocation, Piston To Cylinder .

-- Install the connecting rod bearing cap. Pay attention to the installation position -item  ) OVERVIEW - PISTONS AND CONNECTING ROD-.

-- Install the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals