Checking The Piston Ring Gap
WARNING: This page is about a different variant/trim than selected.
 Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
|
-- Push the piston ring squarely from above down to approximately 15 mm from the bottom end of the cylinder.
-- Use a piston without a piston ring for pushing it in.
| Piston Ring |
New mm |
Wear Limit mm |
| Compression ring |
0.20 +0.15 |
1.0 |
| Oil Scraping Ring |
0.20 +0.20 |
3.0 |