Checking Cylinder Bores

WARNING: This page is about a different variant/trim than selected.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

CAUTION:

- Never handle the cylinder bore with service equipment (drilling, honing, lapping).

-- Using the :VAS6078 , measure in a diagonal sequence at three positions transversely -A- and longitudinally -B-.

Cylinder Bore Diameter in mm
Specified size	74.5 + 0.015 ¹⁾ +0.005

NOTE:

The cylinder bore must not be measured when the cylinder block is mounted on the :VAS6095 because incorrect measurement is possible.