Connecting Rods, Checking Radial Clearance: Procedure
WARNING: This page is about a different variant/trim than selected.
-- Remove the connecting rod bearing cap.
-- Clean the bearing cap and pin.
-- Place the Plastigauge® over the entire width of the bearing journal or into the bearing shells.
-- Install the connecting rod bearing cap and tighten it to 30 Nm without any additional turns. While doing so, do not turn the crankshaft.
-- Remove the connecting rod bearing cap again.
-- Compare the width of Plastigauge® with the measuring scale.
- Radial clearance: 0.028 to 0.065 mm.
-- Replace connecting rod bolts after removing.