LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Crankshaft & Cylinder Block System (General & Service Information - CNLA, CRJA)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Transmission Side >> Sealing Flange, Removing And Installing, Transmission Side >> Assembling

Sealing Flange, Removing And Installing, Transmission Side: Assembling

WARNING: This page is about a different variant/trim than selected.

-- Tighten the sealing flange bolts diagonally.

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Install the oil pan lower section. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .

-- Install the Electric Drive Motor -V141-. Refer to Electric Drive Motor -V141-, ATTACHING TO ENGINE .

-- Connect the Vehicle Diagnostic Tester.

-- After replacing the sensor wheel an adaptation of the combustion misfire must be performed. To do so select the function 01 - Reset combustion misfire adaptation  in Guided Functions  .

scientia non olet · About LEMON Manuals