Catalytic Converter, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
NOTE:
Replace the seal and self-locking nuts.
Coat the exhaust manifold stud bolts with hot bolt paste. Refer to the parts information for the hot bolt paste.
-- Insert the screwdriver -2- into the opening -arrow- on the turbocharger.
-- Pry out the seal -1-.
-- Replace the seal -1-.
NOTE:
Replace the seal and self-locking nuts.
Coat the exhaust manifold stud bolts with hot bolt paste. Refer to the parts information for the hot bolt paste.
-- Install the exhaust system without tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .