Exhaust Gas Temperature Sensor 4 -G648-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different variant/trim than selected.
NOTE:
When removing the wire do not cut it, in this case a fault diagnosis will no longer be possible.
Component location. Refer to COMPONENT LOCATION OVERVIEW - INJECTION SYSTEM - Component Location Overview - Engine from Rear .
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Release and remove the connector. Refer to the figure below;
-- Remove the connector from the bracket.
-- Then free up the wiring harness.
-- Remove the Exhaust Gas Temperature Sensor 4 -G648- -1-.