Exhaust Gas Temperature Sensor 4 -G648-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

-- During installation, all cable ties must be installed at the same location.

CAUTION:

There is a risk of malfunctions from loose exhaust gas temperature sensor.

The exhaust gas temperature sensor threads are coated. Do NOT additionally coat with hot bolt paste and make sure to tighten to the tightening specification.

NOTE:

Protect the exhaust gas temperature sensor against knocks and impacts. A dropped exhaust gas temperature sensor may not be used again.

-- Note the electrical connections and routing. Refer to RELAY CARRIERS, FUSE PANELS AND E-BOXES , the appropriate WIRING DIAGRAM, and OVERVIEW - EXHAUST TEMPERATURE REGULATION .

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .