Exhaust Gas Temperature Sensor 3 -G495-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

NOTE:

During installation, all cable ties must be installed at the same location.

When removing the wire do not cut it, in this case a fault diagnosis will no longer be possible.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Mark the direction of the angled shaft from the Exhaust Gas Temperature Sensor 3 -G495- for reinstallation.

-- Release and remove the connector. Refer to the figure below;

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the connector from the bracket.

-- Then free up the wiring harness.

-- Remove the Exhaust Gas Temperature Sensor 3 -G495- -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.