Exhaust Gas Temperature Sensor 2 -G448-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

NOTE:

When removing the wire do not cut it, in this case a fault diagnosis will no longer be possible.

-- Remove the NOx Sensor -G295- from the emissions control module. Refer to NOx Sensor Control Module -GX30-, REMOVING AND INSTALLING .

-- Release and remove the connector. Refer to the figure below;

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the connector from the bracket.

-- Then free up the wiring harness.

-- Mark the direction of the angled shaft from the Exhaust Gas Temperature Sensor 2 -G448- for reinstallation.

-- It may be necessary for space that the clamp -1- be loosened and turned.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the Exhaust Gas Temperature Sensor 2 -G448- -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.