Exhaust Gas Temperature Sensor 2 -G448-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

-- During installation, all cable ties must be installed at the same location.

CAUTION:

There is a risk of malfunctions from loose exhaust gas temperature sensor.

The thread on the Exhaust Gas Temperature Sensor 2 -G448- is coated. Do NOT coat with hot bolt paste and make sure to tighten to the tightening specification.

NOTE:

Protect the exhaust gas temperature sensor against knocks and impacts. A dropped exhaust gas temperature sensor may not be used again.

-- Note the electrical connections and routing. Refer to RELAY CARRIERS, FUSE PANELS AND E-BOXES , the appropriate WIRING DIAGRAM, and OVERVIEW - EXHAUST TEMPERATURE REGULATION .

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .