Exhaust Gas Temperature Sensor 1 -G235-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

NOTE:

When removing the wire do not cut it, in this case a fault diagnosis will no longer be possible.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Open the heat shield boot.

-- Remove the connector -1- from the bracket and release and remove it.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Then free up the wiring harness.

-- Remove the Exhaust Gas Temperature Sensor 1 -G235- -2-.