Exhaust System, Installing Without Tension: Procedure

WARNING: This page is about a different variant/trim than selected.

-- Loosen the threaded connections on the clamping sleeve -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the exhaust system far enough forward until the pre-load on the retaining loops at the exhaust pipe -a- = 9 mm.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pay attention to the clamping sleeve installation position. Refer to CLAMPING SLEEVE INSTALLATION POSITION .

-- Tighten the clamping sleeve threaded connections evenly.