Vibration Damper, Removing And Installing: Removing

WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, and 2016 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the noise insulation. Refer to NOISE INSULATION .

-- Remove the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Position the engine in the "TDC position for cylinder 1". Refer to VALVE TIMING, CHECKING .

-- Loosen the bolt -arrow- for the vibration damper by using the :T10475 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolt and the vibration damper.

CAUTION:

- Do not turn the crankshaft out of TDC.