Vibration Damper, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, and 2016 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Replace the bolts that were tightened with an additional turn.

-- All surfaces between the bolt, vibration damper and crankshaft toothed belt sprocket must not have any oil or grease on them.

-- Install the vibration damper and install the vibration damper bolt, with an oiled thread, all the way in by hand.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolt -arrow- for the vibration damper by using the :T10475 .

Further installation is performed in reverse order of removal, while noting the following:

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .