Engine Mount, Removing And Installing: Removing

WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, and 2016 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

-- Support the engine in the installation position. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .

-- Disconnect the breather line -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release the tab -3- in the direction of -arrow- and remove the EVAP canister -1- upward.

-- Lay the EVAP canister -1- on the engine with the line attached -2-.

-- Remove the bolt -4- and rotate the washer fluid reservoir filler neck -2- forward.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Open the clip -3- and remove the connector -5- from the coolant expansion tank -1-.

-- Remove the bolts -arrows- and place the coolant expansion tank -1- on the engine with the coolant lines connected.

-- If equipped, remove the jump start terminal -3- on the front engine mount bolt -2- using the :T40055 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -5- and the bracket -4-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -1 and 3- and then remove the engine mount upward.