Air Duct Pipe, Removing And Installing: Installing
WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, and 2016 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Replace the seals after removing.
- Coat the seals lightly with clean engine oil before installing.
- If the release tabs are damaged, the corresponding clips must be replaced.
- If the tabs of the Charge Air Pressure Sensor -GX26- are broken the sensor can be bolted using two bolts.