New Connecting Rod, Separating

New connecting rods might not be separated at the location where they should be. If the connecting rod bearing cap cannot be removed by hand, proceed as follows:

-- Mark the cylinder where the connecting rod belongs. Refer to -item ) PISTON AND CONNECTING ROD - Connecting Rod Bearing Cap.

-- Lightly clamp the connecting rod in a vise equipped with aluminum protective pads.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Clamp the connecting rod lightly to prevent damaging it.

Clamp the connecting rod below the dotted line.

-- Loosen the bolts -arrows- approximately 5 turns.

-- Carefully tap against the connecting rod bearing cap in direction of -arrow- with a plastic hammer until the cap is loose.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.