Overview - Cylinder Block, Transmission Side: Notes

NOTE:

Clutch, Servicing. Refer to CLUTCH (6-Speed Dual Clutch Transmission 02E) , CLUTCH (5-Speed Manual Transmission 0AF) , CLUTCH (Hybrid - Direct Shift Gearbox 0CG) and CLUTCH (Manual Transmission 02Q, 02QA) .

Fig 1: Exploded View Of Cylinder Block, Transmission Side

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1. Central Bolt
   • 90 Nm +90°
   • Replace after removing
2. Crankshaft Toothed Belt Sprocket
3. Bolt
   • 15 Nm
4. Seal
   • Do not lubricate or grease the sealing lip on the seal
   • Replacing. Refer to CRANKSHAFT SEAL, REPLACING, BELT PULLEY SIDE .
5. Sealing Flange on Belt Pulley Side
   • To remove, remove the oil pan. Refer to OIL PAN, REMOVING AND INSTALLING .
   • Must be located on dowel sleeves
   • Removing and installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .
6. Cylinder Block
   • Crankshaft. Refer to CRANKSHAFT .
   • Piston and connecting rod. Refer to PISTON AND CONNECTING ROD .
7. Bolt
   • 60 Nm +90°
   • Replace after removing
8. Flywheel/Drive Plate
   • Drive plate, removing and installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
9. Intermediate Plate
   • Must be located on dowel sleeves. Refer to Identifying Intermediate Plate Alignment Bushing .
   • Be careful not to damage or bend when installing
10. Sealing Flange - Transmission Side With Seal
    • Replace only as a complete unit.
    • Use the support sleeve provided with it when installing
    • To remove, remove the oil pan. Refer to OIL PAN, REMOVING AND INSTALLING .
    • Before installing, remove oil remains from crankshaft journal with a clean cloth
    • Do not lubricate or grease the sealing lip on the seal
    • Supporting sleeve may only be removed after the sealing flange has been slid onto the crankshaft pin.