Right Seal, Replacing: Removing

-- Remove the noise insulation. Refer to NOISE INSULATION .

-- Disconnect the connector -1- from the Oil Level Thermal Sensor -G266-, if equipped.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If equipped, remove the drive axle heat shield from the engine -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the right drive axle from the flange shaft.

-- Tie up the drive axle as high as possible. Do not damage the paint on the drive axle.

-- Place the :SMN372500  or Drip Tray under the transmission.

-- Remove the right flange shaft bolt using, for example, the :T10107A  .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The bolt has a 6 mm inner hex socket

-- To remove and install the flange shaft, install two bolts into the flange and counter hold it using a pry bar.

-- Remove the flange shaft together with the pressure spring.

-- Pry out the gasket.