Camshaft Housing, Removing And Installing: Removing: Notes

WARNING: This page is about a different variant/trim than selected.

-- Remove the toothed belt from the camshaft. Refer to TOOTHED BELT, REMOVING FROM CAMSHAFT .

-- Remove the cylinder head cover. Refer to CYLINDER HEAD COVER, REMOVING AND INSTALLING .

-- Remove the high pressure reservoir (Rail). Refer to HIGH PRESSURE RESERVOIR (RAIL), REMOVING AND INSTALLING .

-- Remove the left coolant pipes. Refer to LEFT COOLANT PIPES, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and press the fuel lines forward.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -2- for the Camshaft Position Sensor -G40-.

-- Disconnect the connector -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolt -1- with the :T10501 and loosen the bolt -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen the bolt -1- and remove the screw-type clamp.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen the bolts -2- and remove the bolts -arrows-.

-- Push the catalytic converter with the particulate filter slightly rearward.