Intake Manifold And Attachments Overview
WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, and 2011 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Follow the safety precautions when working on the diesel direct injection system. Refer to SAFETY PRECAUTIONS .
- Observe the rules for cleanliness. Refer to CLEAN WORKING CONDITIONS .
Always follow these instructions before and during work.
- Intake Manifold
- With the intake flap motor.
- With intake air swirl optimization.
- Must not be disassembled.
- Removing and installing, refer to INTAKE MANIFOLD .
- Bolt
- 8 Nm
- Gasket
- Always replace.
- Seal
- Always replace.
- Connecting PipeCAUTION:
Make sure the connecting pipe coupling element does not bend or stretch. Cracks could develop.
- Always replace.
- Install without tension.
- Bolt
- 20 Nm
- Use the Socket - Xzn 10T10385 for loosening and tightening.
- Gasket
- Always replace.
- Bolt
- 8 Nm
- Throttle Valve Control Module -J338-
- Bolt
- 8 Nm
- Remove and install using the Socket - Xzn 8T40159.
- Bolt
- 8 Nm
- Remove and install using the Socket - Xzn 8T40159.
- Oil Dipstick
- Check the engine oil level. Refer to ENGINE OIL LEVEL, CHECKING .
- Exhaust Gas Recirculation Vacuum Regulator Solenoid Valve -N18-
- With the EGR potentiometer.