Muffler Overview (CJAA)

WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, and 2011 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Muffler And Mounts Overview

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Securing Strap
- For the fuel tank.
Suspended Mount
- Replace if damaged.
Bolt
- 23 Nm
- Always replace.
Retaining Loop
- Replace if damaged.
Exhaust Pipe
Bolt
23 Nm
Suspended Mount
- Replace if damaged.
Rear Muffler
- For repairs, replace each separately.
- Exhaust system, separating and connecting. Refer to EXHAUST SYSTEM, SEPARATING AND CONNECTING .
- Align the exhaust system free of stress. Refer to EXHAUST SYSTEM, INSTALLING .
- Exhaust system, checking for leaks. Refer to EXHAUST SYSTEM, CHECKING FOR LEAKS .
Nut
23 Nm
Repair Clamping Sleeve
- For individual replacement of exhaust pipe and rear mufflers.
- Note the installed position, refer to Fig 2.
- Exhaust system, separating and connecting. Refer to EXHAUST SYSTEM, SEPARATING AND CONNECTING .
- Align the exhaust system free of stress. Refer to EXHAUST SYSTEM, INSTALLING .
- Tighten the nuts evenly
Tunnel Bridge

Fig 2: Clamping Sleeve Location

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- When installing the clamping sleeve, ensure that the bolt end -arrow- does not project beyond the lower edge of clamping sleeve:

Threaded connection points toward the right.
Tighten the threaded connections equally to 23 Nm.