Overview - SUBFRAME Mount

WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, and 2011 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Tightening Specifications

NOTE:

The subframe mount bolts have reduced shanks. They must be replaced.

Subframe Mount, Engine

Fig 1: Identifying Engine Mount & Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A ¹⁾ = 20 Nm +90° turn

B ¹⁾ = 40 Nm +90° turn

C ¹⁾ = 60 Nm +90° turn

¹⁾ Replace after removing

Subframe Mount, Transmission

Fig 2: Identifying Transmission Mount & Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A ¹⁾ = 40 Nm +90° turn

B ¹⁾ = 60 Nm +90° turn

¹⁾ Replace after removing

Pendulum Support

Fig 3: Identifying Pendulum Supports & Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A ¹⁾ = 40 Nm +90° turn

B ¹⁾ = 100 Nm +90° turn

¹⁾ Replace after removing

Removing the pendulum support: Remove the bolt -B- first and then the bolts -A-.

Installing the pendulum support: First tighten the bolts -A- and then bolt -B-.