Cylinder Head Cover Overview
WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, and 2011 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 5 Nm
- Bolt
- 22 Nm
- Protective Strip
- For the fuel rail and high pressure lines.
- Fuel Rail
- With high pressure lines.
- Do not change the angles of the high pressure lines.
- Overview, refer to FUEL RAIL AND INJECTORS OVERVIEW .
- Bolt
- 5 Nm
- Sealing Cap
- Nut
- 10 Nm
- Tensioning Plate
- Always replace.
- Note the installed position, refer to Fig 2.
- Fuel Injector
Overview, refer to FUEL RAIL AND INJECTORS OVERVIEW .
- Bracket
- For the wiring harness.
- Vacuum Hose
- Make sure it is seated correctly and is routed without kinks.
- To the Wastegate Bypass Regulator Valve -N75-.
- Cylinder Head Cover
- Removing and installing, refer to CYLINDER HEAD COVER .
- Gasket
- Replace if damaged or leaking.
- Bolt
- 10 Nm
- Follow the loosening and tightening sequence, refer to CYLINDER HEAD COVER .
- Cap
- Replace the seal if damaged.
- Heat Shield
- Bushing
- For the fuel rail mounting.
- Replace if damaged.