Exhaust Camshaft Balance Shaft: Removing

WARNING: This page is about a different car, the 2013 Volkswagen Jetta and 2012 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the balance shaft timing chain. Refer to BALANCE SHAFT TIMING CHAIN .

-- Remove the bolt -1- and the balance shaft.

Fig 1: Identifying Intake Camshaft Balance Shaft

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

If the balance shaft cannot be removed by hand, use the puller T10394:

-- Install the half shell T10394/1 from the puller T10394.

Fig 2: Identifying Half Shell -T10394/1-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the puller T10394 and push the sliding sleeve in the -direction of the arrow-.

Fig 3: Identifying Installation Of Puller Pieces -T10394- And -T10394/1-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the puller T10055 into the puller T10394 and remove the balance shaft.

Fig 4: Identifying Installation And Operation Of Puller -T10055-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.