Fastener Tightening Specifications
WARNING: This page is about a different car, the 2013 Volkswagen Jetta and 2012 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
| Component | Fastener Size | Nm | ||||||
|---|---|---|---|---|---|---|---|---|
| Charge Air Cooler Mount Bolt | - | 5 | ||||||
| Charge Air Pipe to Cylinder Block | - | 10 | ||||||
| Charge Air Pressure Sensor to Charge Air Pipe Bolt | - | 5 | ||||||
| Charge Air Regulation Vacuum Diaphragm to Turbocharger Bolt | - | 10 | ||||||
| Charge Air System Noise Generator Bracket Nut (3) | - | 8 | ||||||
| Charge Air System Noise Generator to Bracket Bolt (3) | - | 8 | ||||||
| Connection to Turbocharger Bolt | - | 9 | ||||||
| Coolant Return Line Bracket to Turbocharger Bolt | - | 9 | ||||||
| Coolant Return Line to Turbocharger Banjo Bolt | - | 38 | ||||||
| Coolant Supply Line Bracket to Cylinder Block Bolt | - | 9 | ||||||
| Coolant Supply Line to Cylinder Block Banjo Bolt | - | 38 | ||||||
| Coolant Supply Line to Turbocharger Banjo Bolt | - | 38 | ||||||
| Fastening Strip Nut (1) | - | 30 | ||||||
| Oil Return Line to Cylinder Block Bolt | - | 9 | ||||||
| Oil Return Line to Turbocharger Bolt | - | 9 | ||||||
| Oil Supply Line Bracket to Turbocharger Bolt | - | 9 | ||||||
| Oil Supply Line to Cylinder Block Bolt | - | 9 | ||||||
| Oil Supply Line to Turbocharger Banjo Bolt | - | 33 | ||||||
| Plenum Chamber Bulkhead Bolt | - | 8 | ||||||
| Structure Borne Sound Actuator to Bracket Nut (3) | - | 15 | ||||||
| Structure Borne Sound Actuator Bracket to Plenum Chamber Bolt (3) | - | 8 | ||||||
| Structure Borne Sound Control Module to Bracket Bolt (3) | - | 8 | ||||||
| Structure Borne Sound Control Module Bracket to Plenum Chamber Nut (3) | - | 8 | ||||||
| Turbocharger Recirculation Valve to Turbocharger Bolt | - | 7 | ||||||
| Turbocharger Support to Cylinder Block Bolt (2) | - | 30 | ||||||
| Turbocharger Support to Turbocharger Bolt (2) | - | 30 | ||||||
| Wastegate Bypass Regulator Valve to Turbocharger Bolt | - | 3 | ||||||
|
||||||||
Turbocharger Nut Tightening Sequence and Specification
Tighten the nuts in 4 passes in sequence -1 through 5- as follows:
-- Tighten the nuts to 5 Nm.
-- Tighten the nuts to 12 Nm.
-- Tighten the nuts to 16 Nm.
-- Tighten the nuts to 25 Nm.