LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (2.0L - Engine Assembly - Engine Code(S): CBFA & CCTA (Sedan)) >> 10 Engine Assembly >> Description And Operation >> Engine And Transmission Mount Overview

Engine And Transmission Mount Overview

WARNING: This page is about a different car, the 2013 Volkswagen Jetta and 2012 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Assembly Overview: Engine And Transmission Mount
GWWA10-10623Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. Bolt
  2. Bolt
    • 50 Nm + an additional 90° (1/4) turn.
    • Always replace after removing.
    • For the pendulum support to the transmission.
  3. Engine Mount Bracket
  4. Bolt
    • 40 Nm + an additional 180° (1/2) turn.
    • Always replace after removing.
    • For the engine mount bracket to the engine.
  5. Engine Mount
  6. Bolt
    • 40 Nm + an additional 90° (1/4) turn.
    • Always replace after removing.
    • For the engine mount to the body.
  7. Bracket
  8. Bolt
    • 20 Nm + an additional 90° (1/4) turn.
    • Always replace after removing.
    • For the bracket to the body.
  9. Bolt
    • 20 Nm + an additional 90° (1/4) turn.
    • Always replace after removing.
    • For the bracket to the engine mount.
  10. Bolt
    • 40 Nm + an additional 90° (1/4) turn.
    • Always replace after removing.
    • For the engine mount to the body.
  11. Bolt
    • 60 Nm + an additional 90° (1/4) turn.
    • Always replace after removing.
    • For the engine mount to the engine mount bracket.
  12. Pendulum Support
    • First, secure the pendulum support to the transmission, then second, to the subframe.
  13. Bolt
    • 100 Nm + an additional 90° (1/4) turn.
    • Always replace after removing.
    • For the pendulum support to the subframe.
  14. Bolt
    • 60 Nm + an additional 90° (1/4) turn.
    • Always replace after removing.
    • For the transmission mount to the transmission mount bracket.
  15. Bolt
    • 40 Nm + an additional 90° (1/4) turn.
    • Always replace after removing.
    • For the transmission mount to the body.
  16. Transmission Mount
    • The illustration shows the Direct Shift Gearbox (DSG®) version.
  17. Bolt
  18. Transmission Mount Bracket
scientia non olet · About LEMON Manuals