Seat Occupied Recognition Assembly Overview

WARNING:

The passenger occupant detection system service kit is precalibrated and must not be disconnected. The service kit consists of:

WARNING:

Observe safety precautions when working on seat occupied recognition. Refer to PASSIVE OCCUPANT DETECTION SYSTEM SAFETY PRECAUTIONS .

NOTE:

The passenger occupant detection system is only installed in the front passenger side.

Fig 1: Identifying Passenger Occupant Detection System Overview

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Seat Occupied Recognition Pressure Sensor -G452-
- Is a component with the seat occupied recognition mat
- Removing and Installing, refer to PASSIVE OCCUPANT DETECTION SYSTEM
- The connector may be disconnected for removing and installing
Seat Pan
Retaining Clip
Cushion
- For seat pan
- Do not separate from the seat occupied recognition mat -6-
Retaining Clip
- Do not release
Mat
- For seat occupied recognition
- Is a component with the seat occupied recognition pressure sensor -G452-
- Do not separate from the seat pan upholstery -4-
- Removing and Installing, refer to PASSIVE OCCUPANT DETECTION SYSTEM
Mount
- For Seat Occupied Recognition Control Module -J706-
Spreader Pin
- For securing the mount to the seat pan
Electrical Wiring Harness
- Do not separate from the seat occupied recognition pressure sensor -G452- and seat occupied recognition control module -J706-
Passenger Seat Position Sensor -G554-
- Is a component of the electrical wiring harness -9-
- Removing and Installing, refer to SEAT POSITION SENSOR
Seat Occupied Recognition Control Module -J706-
- Removing and Installing, refer to PASSIVE OCCUPANT DETECTION SYSTEM
- Do not disconnect the electrical connector.