Clutch System, Bleeding

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

NOTE:

It is not necessary to pre-fill the system.

For the correct brake fluid, see "Brake System, Bleeding" in General Information .

-- Remove the entire air filter housing, if the bleeder (-arrow- lower illustration) is not accessible. Refer to Removal and Installation .

-- Connect the brake charger/bleeder unit VAS 5234 or V.A.G 1869.

Use the bleeder hose (670 mm) V.A.G 1238/B3.

-- Connect the bleeder hose to the brake bleeder unit collector bottle.

-- Connect the bleeder hose -A- to the bleeder -arrow-.

Fig 1: Connecting Bleeder Hose To Bleeder

Courtesy of AUDI OF AMERICA, LLC

-- Apply 2 bar pressure to the system.

-- Open the bleeder valve approximately 1/4 turn.

-- Press the clutch pedal 15 to 20 times rapidly by hand from stop to stop.

-- Close the bleeder valve and turn the bleeder device off.

-- After completing the bleeding procedure, and the pressure has dropped from 2 bar, press the clutch pedal an additional 10 times by foot.

-- Install the air filter housing, if it was removed earlier. Refer to Removal and Installation .